Lars-André Tokheim, Master student supervision Home
|
Master's
theses: Nitish Jha, “Electrified
calcination in a fludized bed calciner – Experiments with scaled binary
particles”, cooperation with Norcem Brevik, Spring 2023 Lovan Kanabi, “Techno-economic
analysis of green hydrogen production coupled with a system for utilization
of excess heat and oxygen”, cooperation with Skagerag Energi, Spring 2023 Glenn Nedrum, “CO2
capture combined with calcination driven by oxyfuel combustion of green
hydrogen”, cooperation with Norcem Brevik, Spring 2023 Fredrik Høibjerg Kasin,
“The impact of waste heat recovery unit installation on the operation and
control of the raw meal department at Norcem Brevik”, cooperation with Norcem
Brevik, Spring 2022 Syaiful Bahri,
“Utilization of oxygen as partial replacement for air in cement kiln combustion
processes”, cooperation with Norcem Brevik, Spring 2021 Dipendra Khadka,
“Calcination applying H2 combustion in O2 in a CO2
rich atmosphere”, cooperation with Norcem Brevik, Spring 2021 Martin Hagenlund
Usterud, “Calcination in an electrically heated drop tube calciner”,
cooperation with Norcem Brevik, Spring 2021 Nastaran Ahmadpour,
“Calcination in an electrically heated bubbling fluidized bed applied in
calcium looping”, cooperation with Norcem Brevik, Spring 2020 Ron Jacob, “Gas-to-gas
heat exchanger for heat utilization in hot CO2 from an electrically heated
calcination process”, cooperation with Norcem Brevik, Spring 2019 Tommy Basmoen, “Cooling
of Viscous Crude Oil”, cooperation with Equinor, Spring 2019 Umesh Pandy, “Reduction
in Sulphur Emissions from the Norcem Cement Plant in Kjøpsvik”, cooperation
with Norcem Kjøpsvik, Spring 2018 Alireza Hassani,
“Pyrolysis of plastic waste into green fuels – experimental study”,
cooperation with Norner, Spring 2018 Widuramina Sameendranath
Amarasinghe, “Waste heat availability in the raw meal department of a cement
plant”, cooperation with Norcem Brevik, Spring 2017 Kristian Dahl, “Mass and
energy balance of a gasifier rig”, Spring 2017 Azubuike Francis Anene, “Experimental
study of catalysis in plastic pyrolysis”, cooperation with Norner, Spring
2017 Sumudu Karunarathne,
“CFD modeling of mixing in a rotary kiln”, Spring 2016 Paul Rune Brenna
Bekkhus, “Utilization of waste heat from cement kiln exhaust gases for
regeneration of loaded CO2 capture media”, cooperation with Norcem
Brevik, Spring 2016 Fatemeh Asadi, “Steam
drying of wet waste fuels”, cooperation with Norcem Brevik, Spring 2016 Laura Marcano, “Design
and evaluation of heat exchangers used in heat exchange between rich and lean
amine solutions in MEA-based post-combustion CO2 capture plants”,
cooperation with Norcem Brevik, Spring 2015 Denys Zhukov,
“Separation of particles of different size and density in a lab-scale
particle classifier”, Spring 2015 Magnus Folkestad,
“Slip-stream exhaust gas line design”, cooperation with Norcem Brevik, Spring
2015 Maksym Kotenko, “Design
and Aspen Plus simulation of cyclone separation of calcium carbonate
particles”, cooperation with research project FIRCC, Spring 2014 Nataliia Nikolaieva,
“Aspen Plus simulation of calcium looping with indirect heat transfer in the
calciner”, cooperation with research project FIRCC, Spring 2014 Christine Bregge,
“Full-scale NOx reduction experiments at Norcem Brevik”, cooperation with
Norcem Brevik, Spring 2014 Ole Martin Ellefsen,
“Calcium looping with indirect heat transfer in the calciner”, cooperation
with research project FIRCC, Spring 2013 Katrine Thygesen,
“Evaluation of dried sludge as alternative fuel in cement kilns”, cooperation
with Norcem Brevik, Spring 2012 Li Liu, “Biomass Micro
Fuel: Collection, preparation and combustion properties”, cooperation with
Huazhong University of Science and Technology (Wuhan, China), Spring 2011 Øyvind Hasli, “Biomass
Micro Fuel combustion in laboratory kiln”, cooperation with Huazhong
University of Science and Technology (Wuhan, China), Spring 2011 Manjula Pathiranaga, “Evaluation
of rotary kiln modelling results by experimental data from full-scale tests”,
cooperation with Norcem, Spring 2011 Udara Sampath,
“Reduction of NOx emissions from exhaust gases by DeNOx technology”,
cooperation with Yara International, Spring 2010 Øyvind Asgautsen,
“Determination of biomass content in refuse derived fuel”, cooperation with
Norcem Brevik, Spring 2010 Hiromi Ariyaratne,
“Alternative fuels in cement kilns – characterization and experiments”,
cooperation with Norcem AS Brevik, Spring 2009 Ronny Andre Lied,
“Experimental studies of fouling in slurry polyethylene polymerization
reactors”, cooperation with Norner
Innovation, Spring 2008 Ning Wang,
“Environmental production: Use of waste materials in cement kilns in China”,
cooperation with China Cement Association, Spring 2008 Dipesh Shrestha, Process
simulation of CO2 capture from cement plant, cooperation with Norcem Brevik,
Spring 2008 Master
student group projects: Lovan Kanabi, Thanushi
Rajinika Kumarawela and Jiyong Shin, “Electrified calcination combined with
CO2 capture in a fludized bed calciner – Fluidization of scaled binary
particles”, cooperation with Norcem AS Brevik, Fall 2022 Viraj Edirisinghe,
Fredrik Høibjerg, Anders Ytterbø and Nils Aavik, “Calcination of cement raw
meal in a fluidized bed using a binary particle mixture”, cooperation with
Norcem AS Brevik, Fall 2021 Rafid Al-Hawani and
Øyvind Hasli and Liu Li, “Biomass Microfuel Combustion”, cooperation with
Norcem AS Brevik, Fall 2010 Hiromi Ariyaratne and
Benjamin Kaku Arvoh, Thermogravimetric analyzer: “Equipment extension and
evaluation of performance”, Fall 2008 Ning Wang, Prajwal
Shrestha and Mirnes Alic, “Clinker cooler operation”, cooperation with Norcem
AS Brevik, Fall 2007 |